Planning To Repaint Your Car? This Guide May Help You!

Do you just want to change the color of your car or remove its faded or dingy look? Then, it might be time for you to repaint it.

Repainting a car is not as easy as it looks, especially for beginners. However, through good preparation, your car can achieve its new look in no time.

What are the things you will need?

Painting your car by yourself consumes a lot of time. That’s why it is advisable to set aside some time to make the appropriate preparations. Utilize a shed to prevent any elements from sticking to the car’s surface while you’re doing the work.

Before you start, however, make sure that you’ve prepared lots of 1200 and 2000-grit wet-and-dry sandpapers, an air or electric-powered sander, plenty of newspaper and masking tape, an air compressor, a buffet, a spray gun, a pair of safety glasses, paint thinners, several face masks, Topcoat Acrylic, Undercoat, Clear-coat lacquer, and dust extractor.

How to prepare for the work?

1. Remove dust through cleaning your working area.

Hose the entire car. If you are spraying outside, make sure that you don’t paint under the trees or somewhere where contaminants will most likely drop into the wet paint. Next, wash your car and clean its surface from road grime, grease, and dirt. Then, put on your protective eyewear and dust mask and start using the dust extractor.

2. Strip all the way!

Begin sanding away through using circular motions. Don’t forget to sand the corners as well as the crevices of the car. You can reach them by using your hand. The best finishes are often obtained through sanding the whole car back down to the bare metal. Be sure that you’ll get a smooth and even surface by finishing the last part with fine grade wet-and-dry sandpaper.

When removing dust, wipe the entire surface with thinners and rug, and stop. Don’t continue until the thinner’s residue evaporates completely.

3. Be careful in priming.

Use masking tape and plastic sheeting or newspaper in masking up areas that you do not want to repaint. Don’t rush this task to prevent over spraying.

Start mixing the primer along with the thinners. Make use of the recommended ratio from the instructions of the paint can.

4. Practice spraying.

Prior to starting your repainting job, you should be practicing your spraying skills. Look for used car panel or even scrap steel to practice on. When you’re done, hold your spray gun about six inches right from the panel. Now, spray it swiftly in a side-to-side motion.

As paintless dental removal technicians Automotive Repair Systems suggest, apply only the trigger as soon as you move the spray gun. If not, the paint will be a bit thicker in some spots. This may cause runs. Once you already know how to spray correctly, apply the primer thinly on the roof down. Typically, it is advisable for you to take 2 to 3 coats so that you can cover the whole surface.

5. Paint for the win!

Just as you did with the primer, you should mix paint with thinners as per the recommended ratio. Put topcoat paint with the same spraying trick for at least three to four coats. Before you apply the last layer, eliminate the powdery residue through 2000-grit sandpaper and clean it off with a clean and neat rag.

Conclusion

If you’re looking out for a way to save money or practice a DIY ethos, repainting your car yourself is the best option. Through a methodical approach, persistence and some practice, it can be easily achieved.


Leave a Comment